|
reivaj077 (August 27, 2008 at 3:13 am)
Rainwater is very good. I just posted my latest from the rainwater from Fay.
hydrosuper2 (August 15, 2008 at 1:40 am)
We tried Series wired a long time ago it won't work you need the full 13.5 volts across each cell and yes we get best results with the KOH and the cell up to 140 + temp. You have to rember our cell produces more gas under the vacume of the restriction of the air cleaner more air movement across the venturi affect of out special 90. Edge plate design cells don't produce pressure like a flat plate design cell does. so comparing with the upside down bottle test is not a fair test.
h2opower (July 28, 2008 at 8:00 pm)
Lol, always when you want it, it never rains, lol. Just to think we all have been paying for water and it's been falling on our heads for all these years. Guess I am going to buy one of those 1000 gallon containors, but I have about 40 or 50 gallons saved up now, hee hee. Free fuel from the heavens.
BurnerSpecOps (July 28, 2008 at 9:44 am)
I now have my bucket up with an aquarium filter over it....waiting.....where the friggin rain now that I have my bucket!!!
h2opower (July 24, 2008 at 5:52 pm)
Man save that rain water, what are you doing? That water is fully free and cuts cost down too zero, if you don't use any salts of any kind or acids. Look at my cell in use, and note that is pure rain water I am using without the use of salts.Best Regards,h2opower.
coquivagabundo (July 24, 2008 at 5:05 pm)
how far away are the washers separated? looks like 1/4"what was the recommended gap from manufacturer and how much gas was it was rated for.
themiln (July 24, 2008 at 7:02 am)
I noticed on my bros hydro super 2 it takes a while for the production to actually crack when lit, even when the "bubbles are a rolln". I can only put that down to a cold system. So as far as I'm concerned heat is our friend and I'll be installing high temp hosing cause I know the rest of the system can take the heat.
themiln (July 24, 2008 at 6:55 am)
With these units being brute force, I think it would be best having the units setup electrically separate as apposed to in series. You want 12VDC accross each cell and ideally a current limiting pwm for each. Then you don't have to fart around with mixes so much as to worry about too much current drain. Just set the pwm's as high as the fuses and cars charging system can take. |
